x404.co.uk
http://www.x404.co.uk/forum/

New build problems :-[
http://www.x404.co.uk/forum/viewtopic.php?f=4&t=5133		 Page 1 of 2
Author:  boothy_1993 [ Fri Dec 25, 2009 1:09 pm ]
Post subject:  New build problems :-[
well ive finally built my media pc switch it on all lights up yay, no picture. all fans spinning, gpu is onboard. dont know where to start. the psu is making a strange buzzing sound, quite but u can still hear it.

boothy
Author:  JohnSheridan [ Fri Dec 25, 2009 2:41 pm ]
Post subject:  Re: New build problems :-[
Do you hear any "beeping" sounds when you turn it on? The fans may be running but that don't mean anything else is.

Have you checked all the cables especially the hard drive ones - your motherboard probably also uses TWO power leads - the 24pin fat one and also a 4-pin one that goes (usually) near the cpu slot.
Author:  Alexgadgetman [ Fri Dec 25, 2009 3:41 pm ]
Post subject:  Re: New build problems :-[
Have you plugged the monitor in?
:D
Author:  AlunD [ Fri Dec 25, 2009 3:49 pm ]
Post subject:  Re: New build problems :-[
Alexgadgetman wrote:
Have you plugged the monitor in?
:D

:oops: Yeah I know that one :lol:
Author:  phantombudgie [ Sat Dec 26, 2009 11:26 pm ]
Post subject:  Re: New build problems :-[
The buzzing may just be the normal PSU noise :o

Does the hard drive spin up also? A while ago I had a similar thing and my PC would not show anything on the screen, it would get as far as spinning up the HDD and CD drives but it would not beep (as JohnSheridan is probably thinking) to say it completes the Power-On-Self-Test (the "POST" beep, but that sometimes isn't enabled in the motherboard settings). It turns out my RAM had gone west. (I went to the effort of checking my screen, motherboard and graphics card, then took it to a PC shop and the guy chucked in a new stick of RAM and off it went, no problems :oops: )
Author:  rustybucket [ Sun Dec 27, 2009 11:06 am ]
Post subject:  Re: New build problems :-[
JohnSheridan wrote:
Do you hear any "beeping" sounds when you turn it on? The fans may be running but that don't mean anything else is.

Have you checked all the cables especially the hard drive ones - your motherboard probably also uses TWO power leads - the 24pin fat one and also a 4-pin one that goes (usually) near the cpu slot.


In addition check that the graphics card and RAM DIMMs are seated correctly.

Not that I speak from experience or anything... :oops:
Author:  boothy_1993 [ Sun Dec 27, 2009 11:29 am ]
Post subject:  Re: New build problems :-[
yes it is a 24pin and an 4pin they are both plugged in.

the antec 850w psu I have in my gaming rig doesnt make that sound.

tried a different hdd still same thing. i was using the hdmi output on the pc may try the dvi one.

will check the ram when i get back

all seems normal and that post noise does happen.

shall i try an graphics card separately to see if that makes a difference.

boothy
Author:  rustybucket [ Sun Dec 27, 2009 11:31 am ]
Post subject:  Re: New build problems :-[
I would try the DVI port next - they may be switched in the BIOS.
Author:  boothy_1993 [ Sun Dec 27, 2009 11:32 am ]
Post subject:  Re: New build problems :-[
if that does not word an pci-e graphics card (got 2 lying around) xD
Author:  rustybucket [ Sun Dec 27, 2009 11:35 am ]
Post subject:  Re: New build problems :-[
boothy_1993 wrote:
if that does not word an pci-e graphics card (got 2 lying around) xD

:?:

I'm still running an AGP 9600XT because I can't afford new-fangled new newness.

[/envy]
Author:  boothy_1993 [ Sun Dec 27, 2009 11:45 am ]
Post subject:  Re: New build problems :-[
rustybucket wrote:
boothy_1993 wrote:
if that does not word an pci-e graphics card (got 2 lying around) xD

:?:

I'm still running an AGP 9600XT because I can't afford new-fangled new newness.

[/envy]


got a 9600gso (spare) 8800gts (spare) 9800gtx+ (gaming rig) but i still cannot type i mean 'if that does not word' wtf
Author:  boothy_1993 [ Sun Dec 27, 2009 11:54 am ]
Post subject:  Re: New build problems :-[
i forgot to mention that it turns itself off after about 10 seconds then restarts straight after
Author:  bally199 [ Sun Dec 27, 2009 1:40 pm ]
Post subject:  Re: New build problems :-[
boothy_1993 wrote:
i forgot to mention that it turns itself off after about 10 seconds then restarts straight after


You made sure the HSF is properly secured? Sounds like something's overheating to me.
Author:  JJW009 [ Sun Dec 27, 2009 2:10 pm ]
Post subject:  Re: New build problems :-[
bally199 wrote:
boothy_1993 wrote:
i forgot to mention that it turns itself off after about 10 seconds then restarts straight after


You made sure the HSF is properly secured? Sounds like something's overheating to me.

Or possibly shorted out, which would explain the buzzing sound of overloaded coils. Double check every cable is correct and not chafed on the casing. Something simple like plugging in the case LEDs incorrectly can short out the power.

Try booting with everything disconnected except the graphics, memory, power switch and processor to see if you can get into the bios.
Author:  fakesnake [ Mon Dec 28, 2009 9:32 am ]
Post subject:  Re: New build problems :-[
Hi, are you sure all the m/board stand offs are in the correct place? if not they could short the board.
Page 1 of 2 All times are UTC
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/